The UniFi has only the single ethernet port, so much of the OpenWrt documentation is a little confusing. Most of the documentation is written with the idea of routers which have a WAN port, a LAN wired switch and the WLAN wireless. Clearly the Unifi doesn't have the wired LAN switch.Īfter flashing (I found r41163 worked while the 12.09 version had the XM problem discussed above and editing the characters 4-6 didn't fix it) I was able to connect via wired ethernet as described in FirstLogin (i.e. There is a DHCP server handing out IPs in the 192.168.1.X subnet, running on the ethernet port).Īfter changing the password and exiting, I had to wait a while (60 secs?) until I could ssh back into the box. ![]() #TFTP UPGRADE FIRMWARE VERSION 1.255 DOWNLOAD PASSWORD# That was strange because I thought I'd lost networking … I think that is due to a long-running first time ssh key generation. Even so, each ssh in takes a long time to respond (something about recent versions of dropbear taking a long time to setup a session key). I found LUCI not installed, so I had to work to get internet access on the box before I could use that. Once ssh'd into the box I followed these steps:ġ. #TFTP UPGRADE FIRMWARE VERSION 1.255 DOWNLOAD PASSWORD#Įnable wireless, using commands at top of the UCI wireless config page. ![]() ![]() #TFTP UPGRADE FIRMWARE VERSION 1.255 DOWNLOAD SERIAL#.#TFTP UPGRADE FIRMWARE VERSION 1.255 DOWNLOAD INSTALL#.
0 Comments
Leave a Reply. |